KTA Staff

noise hazards

Noise Hazards in the Coatings Industry: Long Term Effects and Hearing Conservation

Primary Contributors to Noise Hazards in the Coatings Industry Continuous exposure to noise above 85 dBA (adjusted decibels) causes permanent damage to the hair cells in the cochlea resulting in irreversible hearing damage.  The National Institute Occupational Safety and Health (NIOSH) recommends 85 dBa as the maximum exposure to noise over an eight hour time […]

Noise Hazards in the Coatings Industry: Long Term Effects and Hearing Conservation Read More »

offshore coating

Meeting the Challenges of Offshore Coating Service: Methods & Materials

Carbon steel or mild steel is a tremendously useful material for construction with its high strength-to-weight ratio, ease of fabrication, low-to-moderate cost, predictable engineering properties, commendable performance and load-carrying capacity. Its Achilles’ Heel, however, is its vulnerability to corrosion. Marine environments are particularly aggressive to steel: a near perfect storm of freely available airborne and

Meeting the Challenges of Offshore Coating Service: Methods & Materials Read More »

nace international

KTA CEO Dan Adley Named NACE International Director – Strategic Planning

KTA-Tator, Inc. CEO Dan Adley Named NACE International Director – Strategic Planning The First At-Large Director to Sit on the NACE Board Pittsburgh, PA – The professional relationship between KTA-Tator, Inc. (KTA) and NACE International dates back 68 years. In that time, KTA employees have participated in local sections, technical committees, conferences, and held leadership

KTA CEO Dan Adley Named NACE International Director – Strategic Planning Read More »

illumination

Importance of Illumination on Coatings Projects

Industrial coatings project specifications invoke many standards and inspection check points that require visual acceptance. Proper illumination of the work area is vital when determining an acceptable product. If there is insufficient light, it is unlikely that a quality inspection of workmanship can be performed. But requiring excessive light and it may not be practical

Importance of Illumination on Coatings Projects Read More »

organic solvent

Effects of Organic Solvent Exposure on Humans

An organic solvent is a chemical that is relatively stable, in the liquid state at temperatures of approximately 0 degree to 250 degree Celsius.  Common organic solvents are classified as alcohols, aromatic hydrocarbons, chlorinated hydrocarbons, aliphatic hydrocarbons, esters, glycol ethers, and ketones. Organic solvents are widely employed since they dissolve, suspend or extract other materials

Effects of Organic Solvent Exposure on Humans Read More »

sling psychrometer

The Psychrometer Duel: Old School vs. New School

Why do we need to measure ambient conditions? Ambient conditions are the prevailing conditions of air temperature, the moisture content of the air (relative humidity), and the temperature at which condensation will occur (dew point).  Most coating specifications have set requirements for monitoring and documenting results for surface and air temperature, relative humidity and dew

The Psychrometer Duel: Old School vs. New School Read More »

spray application

Spray Application – Techniques to Optimize Film Build

When applying coating materials to complex industrial structures, there are several factors that should be considered, including the selection of a spray application method and proper spray technique that will help achieve continuous coverage at the correct thickness. This article describes several techniques that can be used to optimize film build when applying coating materials

Spray Application – Techniques to Optimize Film Build Read More »

coatings e-books

Get Your Three (3) Free Coatings E-Books Today!

Three Free Coatings E-Books have been released by KTA-Tator, Inc in the Spring/Summer of 2017. They are all available below: Measuring Coating Thickness According to SSPC-PA 2 In April of 2017, KTA-Tator, Inc. released a Free E-Book titled “Measuring Coating Thickness According to SSPC-PA 2.” The E-book, written by KTA COO and SSPC Dry Film Thickness

Get Your Three (3) Free Coatings E-Books Today! Read More »