Quiz 4 – Coating Application Inspection

The volume solids content of a product can be found in the:

Prior to primer application, the inspector may be required to:

Over mixing of coatings that require moisture to cure can:

Some multiple component coatings require an induction period, which is:

Shelf life is the period of time:

The information provided by the manufacturer’s PDS (product data sheet):

When there is conflicting information between the specification and the PDS (product data sheet), for example, a difference between the surface preparation required or the dry film thickness required:

It is a “best practice” to inventory all coating products for a job:

A material receipt inspection involves:

Most coating manufacturers and project specifications prohibit:

The mixing of a multi-component zinc rich primer requires:

An experienced contractor doesn’t need to “measure” thinner; they can gage how much to add by the look and feel of the thinned product.

According to SSPC-PA 2, what is the minimum number of gage readings that are obtained in each spot?

According to SSPC-PA 2, what is the number of spot measurements that are obtained in each 100 square foot area?

SSPC-PA 2 has been invoked by the specification. The surface that was coated is 5,750 square feet. Based on that area, which of the following is correct?

According to SSPC-PA 2 Restriction Level 3, what is the tolerance of the spot measurements?

Which of the following statements is true regarding low voltage (wet sponge) holiday detection?

Calculate the correct voltage setting for a coating that was applied 60 mils thick.

Calculate the target wet film thickness using the following data:

DFT: 8 mils
Volume Solids: 59%
Target WFT:   ___________ (Fill In The Blank)

Calculate the target wet film thickness using the following data:

DFT: 6 mils
Volume Solids: 82%
Thinner added: 12%
Target WFT: _______ (Fill in the blank as a number)